Check the following points once again if you are having some
trouble with your Combination VCR.
No power...
• Check that the Power Plug dSc(J_ptetely connected to
an AC outlet.
• Check that the POWER button is set to on.
No picture or suuJ_d...
Poor picture with normal sou,_d..
Poor sound with normal picture...
Poor TV reception...
No color or poor color...
Ghosts (Multiple images)...
TV programs can't be watched...
TV progran_ catlt be lecorded...
Cannot record a stereo or SAP broadcast.
Timer recording can't be performed...
There's no playback picture or the playback pbcture hsnonsy
or contains streaks...
• Make sure your anten_a o_cable system _scen_ected to
the Combination VCR. (P.5)
• Check that the power plug is completely connected to an
AC outlet.
• Check that the POWER button is set to on.
• Adjust the BRIGHT, SHARPNESS, and PICTURE
controls in the SET UP TV menu. (P.10)
• Adjust theVOLUMEcontrol. (P.10)
• Adjust the SHARPNESS and PICTURE controls in the
SET UP TV menu. (P.10)
• Adjust the TINT and COLOR controls in the SET UP TV
menu. (P.10)
• Install a directional antenna.
• Make sure that the channel being received is in the
Combination VCRs memory. (P.6)
• Make sure your antenna or cable system is cur[_ected to
the Combination VCR. (P.5)
• Make sure that the record tab on the back of the
cassette is still intact. (P.5)
• This unit is not designed for stereo/SAP broadcast
recording.
• Set the recording start/stop time correctly. (P.16-17)
• Timer recording may not be performed or continued if a
power interruption of more than 1 minute occurs before
or during Timer Recording, even if power resumes
thereafter.
• Adjust the TRACKING control slowly in either direction.
(P.13)
Combination VCR can't be remote controlled...
• Aim the Remote Control directly at tile lun_ote sensor on
the Combination VCR. (Refer to Control Reference Guide.)
• Avoid all obstacles which may interfere with the signal path.
• Inspect or replace the batteries. (P.2)
Video cassette can't be inserted...
Video cassette can't be removed..
Eject does not function or insertion can__uLbe done..
Video cassette ejects when the REC and PLAY buttons are
pressed or when the two minutes before the Timer
Recording starts...
In the stop mode, the motor (CYLINDER) continues to
rotate...
• Insert the cassette with the winduw side up and the
record tab facing you.
• Check that the power plug is completely connected to an
AC outlet.
• Turn the POWER off and then on, and try ejecting or
inserting the tape again.
• Make sure the record tab on the back of the cassette is
still intact. (P.5)
• To enable the quick play mechanism, the cylinder will
rotate for about 5 minutes.
• The quick play mechanism reduces response time from Sto
to Play mode and from Play to Rewind search mode.
21
To Next Page
Loading...
