6.2. Removal of Upper Case
1. Lift the rear side of the top panel and disconnect the top
panel Open/Close hook, then open the top panel.
2. While pressing hooks of the 2 top panel fastening devices,
remove the top panel.
3. Loosen the 3 screws until they idle.
4. Slide the lamp lock button to release, and remove the lamp
unit block (with lamp unit cover).
5. Unscrew the 8 screws and remove the upper case.
6.3. Removal of A-P.C.Board
1. Remove the upper case according to the section 6.2.
"Removal of Upper Case".
2. Unscrew the 2 screws and remove the A-P.C.Board block.
3. Unscrew the 2 screws and remove the connector cover.
4. Unscrew the 11 screws and remove the A-P.C.Board.
16
PT-AE2000U / PT-AE2000E
To Next Page
Loading...
