Panasonic PT-AE2000U

3. Unscrew the 1 screw and release the grounding terminal.
4. Unscrew the 4 screws and remove the block of Analysis
Block, LCD Block, Shift Mechanism and Projection Lens.
5. Unscrew the 2 screws and remove the block of LCD Block,
Shift Mechanism and Projection Lens.
Note:
· There is not enough space between the analysis
block and LCD block. Be careful not to damage nor
dirty precision components (LCD panel, phase
difference board, etc.) when removing.
6.12. Removal of LCD Block /
Projection Lens
1. Remove the block of LCD Block, Shift Mechanism and
Projection Lens according to the section 6.11. "Removal of
Analysis Block".
2. Unscrew the 5 screws, and separate the LCD block and
block of Shift Mechanism and Projection Lens.
3. Unscrew the 4 screws and remove the projection lens .
6.13. Replacement of Phase
Difference Board
The procedure is described as an example of phase difference
board (G).
1. Remove the upper case according to the section 6.2.
"Removal of Upper Case".
2. Unscrew the 2 screws and remove the A-P.C.Board block.
3. Mark positions of the phase difference board (G).
Note:
· Mark accurately as possible because the marks will
be used for resetting the phase difference board
position.
4. Unscrew the 1 screw and remove the phase difference
board (G).
21
PT-AE2000U / PT-AE2000E