Panasonic PT-AE2000U

4. Unscrew the 1 screw and remove the P.C.Board
attachment fittings with R-P.C.Board.
Note:
· R-P.C.Board is secured. Be careful not to apply
excessive force.
5. Unscrew the 1 screw and release the grounding terminal.
6. Unscrew the 1 screw and release the grounding terminal.
7. Unscrew the 4 screws and remove the block of Analysis
Block, LCD Block, Shift Mechanism and Projection Lens.
8. Unscrew the 2 screws and remove the exhaust fan.
9. Unscrew the 1 screw and release the lamp unit terminal.
10. Unscrew the 3 screws and remove the power block (B/Q-
Module and P-Module).
11. Unscrew the 1 screw and separate the B/Q-Module block
and P-Module block.
12. Unscrew the 2 screws.
13. While pressing to shut each hook of the 2 resinous stands,
remove the B/Q-Module.
6.9. Removal of P-Module
1. Remove the P-Module block according to the steps 1
through 11 in the section 6.8. "Removal of B/Q-Module".
2. Unscrew the 2 screws.
19
PT-AE2000U / PT-AE2000E