Panasonic PT-FZ570U

Chapter 4 Settings — [PROJECTOR SETUP] menu
ENGLISH - 93
f
When [IN STANDBY MODE] is set to [ON] and the digital signal is input, the audio output is interrupted during the cooling period after the
power is turned off, but this is not a malfunction.
Setting the mute
1) Press as to select [AUDIO SETTING].
2) Press the <ENTER> button.
f
The
[AUDIO SETTING]
screen is displayed.
3) Press as to select [MUTE].
4) Press qw to switch the item.
f
The items will switch each time you press the button.
[OFF]
Audio is output.
[ON]
Audio is not output.
Setting audio input selection
Choose the audio input terminal for each input signal.
1) Press as to select [AUDIO SETTING].
2) Press the <ENTER> button.
f
The
[AUDIO SETTING]
screen is displayed.
3) Press as to select one item of [AUDIO IN SELECT].
[COMPUTER1]
Set the audio output when [COMPUTER1] input is selected.
[COMPUTER2]
Set the audio output when [COMPUTER2] input is selected.
[VIDEO]
Set the audio output when [VIDEO] input is selected.
[HDMI1]
Set the audio output when [HDMI1] input is selected.
[HDMI2]
Set the audio output when [HDMI2] input is selected.
[DIGITAL LINK]
Set the audio output when [DIGITAL LINK] input is selected.
[NETWORK]
Set the audio output when [NETWORK] input is selected.
4) Press qw to switch the item.
f
The sub items will switch each time you press the button.
[COMPUTER1]
Select one item among [AUDIO IN 1], [AUDIO IN 2] or [AUDIO IN 3].
[COMPUTER2]
Select one item among [AUDIO IN 1], [AUDIO IN 2] or [AUDIO IN 3].
[VIDEO]
Select one item among [AUDIO IN 1], [AUDIO IN 2] or [AUDIO IN 3].
[HDMI1]
Select one item among [HDMI1 AUDIO IN], [AUDIO IN 1], [AUDIO IN 2] or [AUDIO IN 3].
[HDMI2]
Select one item among [HDMI2 AUDIO IN], [AUDIO IN 1], [AUDIO IN 2] or [AUDIO IN 3].
[DIGITAL LINK]
Select one item among [DIGITAL LINK AUDIO IN], [AUDIO IN 1], [AUDIO IN 2] or [AUDIO IN 3].
[NETWORK]
Select one item among [NETWORK AUDIO IN], [AUDIO IN 1], [AUDIO IN 2] or [AUDIO IN 3].
[TEST PATTERN]
Displays the test pattern built-in to the projector.
Settings of position, size, and other factors will not be reected in test patterns. Make sure to display the input
signal before performing various adjustments.
1) Press as to select [TEST PATTERN].
2) Press the <ENTER> button.
f
The test pattern with the
[PATTERN CHANGE]
individual adjustment screen is displayed.
3) Press qw to switch the test pattern.
f
The test pattern will switch each time you press the button.
f
When you press the <MENU> button or the <RETURN> button, it will exit the test pattern and return to the
sub menu of [PROJECTOR SETUP].