Panasonic PT-JW130FWE

Chapter 4 Settings — [PICTURE] menu
ENGLISH - 65
f The [USER] setting is shared with [User P] in the Content Manager. Changes to the [USER] setting are also reected in [User P]. (“[Color]”
(x page 198))
Adjusting desired white balance
1) Press as to select [COLOR TEMPERATURE].
2) Press qw or the <ENTER> button.
f The [COLOR TEMPERATURE] individual adjustment screen is displayed.
3) Press qw to select [USER].
4) Press the <ENTER> button.
f The [COLOR TEMPERATURE] screen is displayed.
5) Press as to select [RED], [GREEN], or [BLUE].
6) Press qw to adjust the level.
Item Operation Adjustment Range of adjustment
[RED]
Press w.
Deepens red.
0 - +255
(Factory default is +255)
Press q.
Weakens red.
[GREEN]
Press w.
Deepens green.
Press q.
Weakens green.
[BLUE]
Press w.
Deepens blue.
Press q.
Weakens blue.
Note
f Adjust [COLOR TEMPERATURE] correctly. All colors will not be displayed properly unless adequate adjustment is made. If the adjustment
does not look suitable, you can press the <DEFAULT> button on the remote control to return the setting for the selected item only to the
factory default setting.
f The setting of [COLOR TEMPERATURE] is not reected in internal test patterns (x page 91). Make sure to set [COLOR
TEMPERATURE] while the input signal is projected.
[DIMMER]
Adjust the brightness.
1) Press as to select [DIMMER].
2) Press qw or the <ENTER> button.
f The [DIMMER] individual adjustment screen is displayed.
3) Press qw to adjust the level.
Operation Adjustment Range of adjustment
Press w.
Makes brighter.
0 - +100
(Factory default is +100)
Press q.
Makes darker.
Note
f Video images may appear reddish depending on the set value.
f The set value for [DIMMER] is reected in [DIMMER] (x page 62) in [LIGHTING].