Panasonic PT-JW130FWE

Chapter 4 Settings — [SETUP] menu
74 - ENGLISH
[STATUS]
Display the status of the projector.
1) Press as to select [STATUS].
2) Press the <ENTER> button.
f The [STATUS] screen is displayed.
3) Press qw to switch the pages.
f The page will change each time you press the button.
[INPUT]
Displays the currently selected input.
[SIGNAGE]
Displays the status of signage playback.
[SIGNAL NAME]
Displays the input signal name.
[SIGNAL FREQUENCY]
Displays the frequency of the input signal.
[PROJECTOR RUNTIME]
Displays the runtime of the projector.
[INTAKE AIR TEMP.]
Displays the status of the air intake temperature of the projector.
[OPTICS MODULE TEMP.]
Displays the status of the internal temperature of the projector.
[PROJECTOR TYPE]
Displays the type of the projector.
[SERIAL NUMBER]
Displays the serial number of the projector.
[MAIN VERSION]
Displays the main version of the rmware of the projector.
[SUB VERSION]
Displays the sub version of the rmware of the projector.
[NETWORK VERSION]
Displays the network version of the projector.
Note
f The content of status can be sent via E-mail to E-mail addresses (up to two) set in “[E-mail set up] page” (x page 116) by pressing the
<ENTER> button while the [STATUS] screen is displayed.
[DATE AND TIME]
Set the time zone, date, and time of the built-in clock of the projector.
Setting the time zone
1) Press as to select [DATE AND TIME].
2) Press the <ENTER> button.
f The [DATE AND TIME] screen is displayed.
3) Press as to select [TIME ZONE].
4) Press qw to switch [TIME ZONE].
Setting the date and time manually
1) Press as to select [DATE AND TIME].
2) Press the <ENTER> button.
f The [DATE AND TIME] screen is displayed.
3) Press as to select [ADJUST CLOCK].
4) Press the <ENTER> button.
f The [ADJUST CLOCK] screen is displayed.
5) Press as to select an item, and press qw to set the local date and time.
6) Press as to select [APPLY], and press the <ENTER> button.
f The setting of the date and time will be completed.