Panasonic PT-LW373

ENGLISH - 39
Making adjustments and selections
It is recommended that images are projected continuously for at least 30 minutes before the focus is adjusted.
3)
5)
3)
1) Adjust the focus of the image roughly. (x page 40)
2) Change the settings of the [Display] menu → [Project way] depending on the installation mode.
(x page 54)
f Refer to “Navigating through the menu” (x page 47) for the operation of the menu screen.
3) Press the <INPUT/ENTER> button on the control panel or the input selection (<COMPUTER 1>,
<COMPUTER 2>, <HDMI>, <VIDEO>, <MEMORY VIEWER/USB DISPLAY/NETWORK>) buttons on the
remote control to select the input signal.
f The <COMPUTER 2> button is only for PT-LW373, PT-LW333, PT-LB423, PT-LB383 and PT-LB353, it is disabled for
PT-LB303.
f The <MEMORY VIEWER/USB DISPLAY/NETWORK> button is only for PT-LW373, PT-LW333, PT-LB423, PT-LB383
and PT-LB353. The <MEMORY VIEWER/USB DISPLAY> button is for PT-LB303 and it is disabled.
4) Adjust the front and back tilt of the projector with the adjustable foot. (x page 31)
5) Press the <AUTO SETUP> button on the remote control.
6) Adjust the size of the image to match the screen with the zoom ring.
7) Adjust the focus with the focus ring.
Powering Off the Projector
1) 2)
3)
1) 2)
1) Press the power <v/b> button on the control panel or on the remote control.
f The following message appears.
2) Press the power <v/b> button on the control panel or on the remote control again.
f Projection of the image will stop, and the power indicator <ON(G)/STANDBY(R)> blinks in red. (The fan keeps running.)
3) Wait until the power indicator <ON(G)/STANDBY(R)> lights in red.
f The projector enters standby mode when the power indicator <ON(G)/STANDBY(R)> lights in red.
Note
f While the power indicator <ON(G)/STANDBY(R)> is blinking in red, the lamp is being cooled down and the projector cannot
be turned on. Wait until the power indicator <ON(G)/STANDBY(R)> lights in red to turn on the projector again.
f When packing the projector for transportation and storage, please make sure that each indicator is off.
Chapter 3 Basic Operations - Powering on/off