ENGLISH - 51
Input menu
To select the input source directly by pressing the input selection buttons on the remote control or to select the
input source in the Input screen by pressing the <INPUT/ENTER> button on the control panel.
Switching the input source
When using the remote control
1) Press the input selection (<COMPUTER 1>, <COMPUTER 2>, <HDMI>, <VIDEO>, <MEMORY VIEWER/
USB DISPLAY/NETWORK>) buttons.
f The <COMPUTER 2> button is only for PT-LW373, PT-LW333, PT-LB423, PT-LB383 and PT-LB353, it is disabled for
PT-LB303.
f The <MEMORY VIEWER/USB DISPLAY/NETWORK> button is only for PT-LW373, PT-LW333, PT-LB423, PT-LB383
and PT-LB353. The <MEMORY VIEWER/USB DISPLAY> button is for PT-LB303 and it is disabled.
f The selected input signal will be projected.
<COMPUTER 1>
Press this button to switch to Computer 1/Component input.
<COMPUTER 2>
Switch to Computer 2 input.
<HDMI >
Switch to HDMI input.
<VIDEO>
Press this button to switch to Video/S-video input.
<MEMORY VIEWER/
USB DISPLAY/
NETWORK>
Press this button to switch to Memory Viewer/USB Display/Network input.
When using the control panel
1) Press the <INPUT/ENTER> button.
f The Input screen is displayed.
For PT-LW373, PT-LW333, PT-LB423,
PT-LB383 and PT-LB353
For PT-LB303
2) Press as to select one item and then press the <ENTER> button.
f The selected input signal will be projected.
Note
f The still-image transmission application software “Presenter Light” (x page 85) or “VueMagic Pro” (x page 86)
is
necessary while projecting [Network] input.
Chapter 4 Settings - Input menu
To Next Page
Loading...
