Panasonic PT-LW376

38 - ENGLISH
Powering on/o󰀨
Connecting the power cord
Make sure that the supplied power cord is securely xed to the <AC IN> terminal of the projector body to
prevent it from being removed easily.
For details of power cord handling, refer to “Read this rst!” (x page 4).
Attaching
1) Check the shapes of the <AC IN> terminal on the back of the projector body and the power cord
connector and insert the connector completely in the correct direction.
Removing
1) Confirm that the projector is in standby mode, and remove the power plug from the outlet.
2) Remove the power cord connector from the <AC IN> terminal.
Power indicator
The power indicator <ON(G)/STANDBY(R)> informs you the status of the power. Conrm the status of the power
indicator <ON(G)/STANDBY(R)> before operating the projector.
VOL-
VOL+
AV MUTE
Power indicator <ON(G)/STANDBY(R)>
Indicator status Status
O󰀨 The power plug is not connected to the outlet.
Red
Lit
The power is switched o󰀨 (in standby mode). The [PROJECTOR SETUP] menu → [ECO MANAGEMENT] →
[STANDBY MODE] is set to [ECO].
Blinking*
1
The power is switched o󰀨 (in standby mode). The [PROJECTOR SETUP] menu → [ECO MANAGEMENT] →
[STANDBY MODE] is set to [NETWORK].
Blinking*
2
The power is switched o󰀨 (in standby mode). The [PROJECTOR SETUP] menu → [ECO MANAGEMENT] →
[STANDBY MODE] is set to [NORMAL].
x
Chapter 3 Basic Operations - Powering on/o󰀨