Panasonic PT-LW376

ENGLISH - 75
3) Press as to select a projector ID.
f Select one from [ALL], and [1] to [6].
[ALL]
Select when controlling projectors without specifying an ID number.
[1] - [6]
Select when specifying an ID number to control individual projector.
4) Press the <ENTER> button to set it.
f [PROJECTOR ID] is set.
Note
f To specify an ID number for individual control, the ID number of a remote control must match the ID number of the projector.
f When the ID number is set to [ALL], the projector will operate regardless of the ID number specied during remote control or computer
control.
If multiple projectors are set up side by side with ID set to [ALL], they cannot be controlled separately from the projectors with other ID
numbers.
f Refer to “Setting the ID number of the remote control” (x page 49) for how to set the ID number on the remote control.
[INITIAL START UP]
Set the startup method when the projector is switched on after connecting the power plug to outlet.
1) Press as to select [INITIAL START UP].
2) Press qw to switch the item.
f The items will switch each time you press the button.
[LAST MEMORY]
Starts up in the status that before removing the power plug from the outlet or turning o󰀨 the circuit breaker.
[STANDBY]
Starts up in the standby mode.
[ON]
Starts the projection immediately.
[PROJECTION METHOD]
Set the projection method in accordance with the installation status of the projector.
Change the projection method if the screen display is upside down or inverted.
1) Press as to select [PROJECTION METHOD].
2) Press qw to switch the projection method.
f The items will switch each time you press the button.
[AUTO]
Detects the projector’s posture with built-in angle sensor, then switches to [FRONT/DESK] or [FRONT/CEILING].
Usually it is set to [AUTO] when projecting in front of the screen.
[FRONT/DESK]
Select when installing the projector on the desk, etc., in front of the screen.
[FRONT/CEILING]
Select when installing the projector in front of the screen with the Ceiling Mount Bracket (optional).
[REAR/DESK]
Select when installing the projector on the desk, etc. behind the screen (with a translucent screen).
[REAR/CEILING]
Select when installing the projector behind the screen (with a translucent screen) with the Ceiling Mount
Bracket (optional).
Note
f When set to [AUTO], front projection or rear projection cannot be detected. When projecting from rear, please set the [PROJECTION
METHOD] to [REAR/DESK] or [REAR/CEILING].
f Refer to “Angle sensor” (x page 29) for details on the range of the installation attitude that can be detected by the built-in angle sensor.
[HIGH ALTITUDE MODE]
Change the setting according to the altitude in which you use the projector.
1) Press as to select [HIGH ALTITUDE MODE].
2) Press qw to switch the item.
f The items will switch each time you press the button.
[OFF]
Select when using the projector in the elevation of below 700 m (2 297').
[HIGH1]
Select when using the projector in the elevation of above 700 m (2 297') and below 1 400 m (4 593′).
[HIGH2]
Select when using the projector in the elevation of above 1 400 m (4 593′) and below 2 700 m (8 858′).
Chapter 4 Settings - [PROJECTOR SETUP] menu