Panasonic PT-MZ11K

Chapter 1 Preparation — About your projector
ENGLISH - 33
r Connecting terminals
2 3
4 5
1
6 7 8 9 10
1 <USB> terminal
This is a terminal to connect the USB memory when using the
data cloning function or rmware update function.
(x pages 225, 231)
This is also the terminal to connect the optional Wireless
Module (Model No.: AJ-WM50 Series) when the projector is
connected via wireless LAN. (x page 180)
2 <SDI IN> terminal
This is a terminal to input the SDI signal.
3 <HDMI IN 1> terminal / <HDMI IN 2> terminal
These are the terminals to input HDMI signal.
4 <DIGITAL LINK> terminal
This is a terminal to connect a device that transmits image
signal via the LAN terminal. Also, this is the LAN terminal to
connect to the network.
5 <LAN> terminal
This is the LAN terminal to connect to the network.
6 <DC OUT> terminal
This is the USB terminal dedicated for power supply. (DC 5 V,
maximum 2.0 A)
Use this terminal when a power supply is required to wireless
display adapters and wireless LAN/Ethernet converters, etc.
7 <SERIAL/MULTI SYNC IN> terminal
This is the RS-232C compatible terminal to externally control
the projector by connecting a computer.
This terminal is also used to connect multiple projectors when
balancing the contrast as a combined screen or synchronizing
the e󰀨ects using the shutter function including the fade in/fade
out with a system using multiple projectors.
8 <SERIAL/MULTI SYNC OUT> terminal
This is a terminal to output RS-232C compliant signal input to
the <SERIAL/MULTI SYNC IN> terminal.
This terminal is also used to connect multiple projectors when
balancing the contrast as a combined screen or synchronizing
the e󰀨ects using the shutter function including the fade in/fade
out with a system using multiple projectors.
9 <REMOTE 1 IN> terminal
This is a terminal to remotely control the projector using the
external control circuit.
10 <REMOTE 2 IN> terminal/<REMOTE 2 OUT> terminal
These are terminals to connect the remote control for serial
control in a multiple projector environment.
Attention
f When a LAN cable is directly connected to the projector, the network connection must be made indoors.
f When connecting a USB memory to the <USB> terminal, also refer to “Using the USB memory” (x page 73).
f To transmit the Ethernet and serial control signals using the <DIGITAL LINK> terminal, set the [NETWORK] menu → [ETHERNET TYPE] to
[DIGITAL LINK] or [LAN & DIGITAL LINK].
f To transmit the Ethernet signal using the <LAN> terminal, set the [NETWORK] menu → [ETHERNET TYPE] to [LAN] or [LAN & DIGITAL
LINK].
f The <DIGITAL LINK> terminal and the <LAN> terminal are connected inside of the projector when the [NETWORK] menu → [ETHERNET
TYPE] is set to [LAN & DIGITAL LINK]. Do not directly connect the <DIGITAL LINK> terminal and the <LAN> terminal using a LAN cable.
Construct the system so that it is not connected to the same network via the peripherals such as the switching hub or the twisted-pair-cable
transmitter.
f When the [PROJECTOR SETUP] menu → [STANDBY MODE] is set to [NORMAL], power can be supplied by using the <DC OUT> terminal
even while the projector is in standby mode. If [ECO] is set, power cannot be supplied in standby mode.