Chapter 4 Settings — [PROJECTOR SETUP] menu
148 - ENGLISH
Sending status content via E-mail
The status content can be sent to the E-mail address (up to two addresses) set in “[E-mail set up] page”
(x page 207).
1) Press the <ENTER> button while the 1/5 to 4/5 page of the [STATUS] screen is displayed.
f The selection screen is displayed.
2) Press as to select [SEND E-MAIL].
3) Press the <ENTER> button.
f The [SELECT E-MAIL ADDRESS] screen is displayed.
4) Press as to select the destination.
5) Press the <ENTER> button.
f The conrmation screen is displayed.
6) Press qw to select [OK], and press the <ENTER> button.
f The status content is sent.
Saving status content in USB memory
The status content can be saved in a USB memory attached to the <USB> terminal.
1) Press the <ENTER> button while the 1/5 to 4/5 page of the [STATUS] screen is displayed.
f The selection screen is displayed.
2) Press as to select [SAVE TO USB MEMORY].
3) Press the <ENTER> button.
f The conrmation screen is displayed.
4) Press qw to select [OK], and press the <ENTER> button.
f The status content is saved.
Note
f For the USB memory that can be used with the projector and handling of the memory, refer to “Using the USB memory” (x page 73).
[INFO MONITOR SETTING]
Set the information monitor of the control panel.
For operation of the information monitor, refer to “Using the information monitor function” (x page 213).
Setting the display during normal status
Display/hide the information monitor during no operation.
1) Press as to select [INFO MONITOR SETTING].
2) Press the <ENTER> button.
f The [INFO MONITOR SETTING] screen is displayed.
3) Press as to select [DEFAULT].
4) Press qw to switch the item.
f The items will switch each time you press the button.
[OFF] Does not display the information.
[USER VIEW]
Displays the items set in the [PROJECTOR SETUP] menu → [INFO MONITOR SETTING] → [USER
VIEW].
Note
f Even if [DEFAULT] is set to [OFF], the content of an error or a warning is automatically displayed when it occurs.
f This can also be set with operation in the information monitor. For details, refer to “Using the information monitor function” (x page 213).
To Next Page
Loading...
