Panasonic PT-MZ17K

Chapter 3 Basic Operations — Switching on/o󰀨 the projector
ENGLISH - 55
How to remove the power cord
1) Confirm that the <MAIN POWER> switch on the side of the projector is on the <OFF> side, and
remove the power plug from the outlet.
2) Raise the power cord holder fixing the power cord upward. (Fig. 1)
f Fix the power cord holder by snapping into the projector.
3) While holding the power cord connector, pull out the power cord from the <AC IN> terminal of the
projector. (Fig. 2)
Power indicator
Indicate the status of the power. Check the status of the power indicator <ON (G)/STANDBY (R)> before operating
the projector.
Indicator status Projector status
O󰀨 The main power is switched o󰀨.
Red
Lit
The power is switched o󰀨. (standby mode)
Projection will start when the <POWER ON> button is pressed.
f The setting of the projector is as follows.
g The [PROJECTOR SETUP] menu → [QUICK STARTUP] is set to [OFF].
f The projector may not operate when the light source indicator <LIGHT> or the
temperature indicator <TEMP> is blinking. (x page 239)
Blinking
The power is switched o󰀨. (standby mode)
Projection will start when the <POWER ON> button is pressed.
f The projector is in one of the following states.
g The [PROJECTOR SETUP] menu → [QUICK STARTUP] is set to [ON].
g When previewing the image corresponding to the input image to the projector
with the web control function. For details, refer to “[Remote preview lite] page”
(x page 186).
f The indicator will change to a red light when the specied time has elapsed after the
projector enters the standby mode if the projector is set as following.
The specied time is the time set in the [PROJECTOR SETUP] menu → [QUICK
STARTUP] → [VALID PERIOD].
g The [PROJECTOR SETUP] menu → [QUICK STARTUP] is set to [ON].
f The projector may not operate when the light source indicator <LIGHT> or the
temperature indicator <TEMP> is blinking. (x page 239)
Green Lit Projecting.
Orange Lit
The projector is preparing to switch o󰀨 the projector.
The power is switched o󰀨 after a while. (Changes to the standby mode.)
Fig. 1 Fig. 2
Power indicator <ON (G)/STANDBY (R)>