Panasonic PT-MZ17K

Chapter 1 Preparation — About your projector
ENGLISH - 29
About your projector
Remote control
1
3
2
4
5
7
6
8
9
10
17
12
11
13
16
14
15
18
19
1 <STANDBY> button
Sets the projector to the state where the projector is turned
o󰀨 (standby mode) when the <MAIN POWER> switch on the
projector is set to <ON> and in projection mode.
2 <POWER ON> button
Sets the projector to projection mode when the <MAIN
POWER> switch on the projector is set to <ON> and the power
is turned o󰀨 (standby mode).
3 Remote control indicator
Blinks if any button in the remote control is pressed.
4 Lens buttons (<FOCUS>, <ZOOM>, <SHIFT>)
Adjusts the focus, zoom, and lens shift. (x page 68)
5 <MENU> button/<ENTER> button/asqw buttons
Used to navigate through the menu screen. (x page 79)
asqw buttons are also used to enter the password in
[SECURITY] or enter characters.
6 <ON SCREEN> button
Switches the on-screen display function on (display) or o󰀨
(hide). (x page 74)
7 Input selection buttons (<HDMI 1>, <HDMI 2>, <DIGITAL
LINK>, <SDI>)
Switches the input signal to project. (x page 67)
8 <FUNCTION> button
Assigns a frequently used operation as a shortcut button.
(x page 75)
When the <FUNCTION> button is held down, the [FUNCTION
BUTTON] screen is displayed. (x page 145)
9 Number (<0> - <9>) buttons
Used for entering an ID number or a password in a multiple
projector environment.
10 <ID ALL> button
Used to simultaneously control all the projectors with a single
remote control in a multi-projector environment. (x page 34)
11 <SHUTTER> button
Used to temporarily turn o󰀨 the image. (x page 74)
12 <TEST PATTERN> button
Displays the test pattern. (x page 75)
13 <CEC> button
Displays the HDMI-CEC operation screen.(x page 229)
14 <INPUT MENU> button
Displays the input selection screen.(x page 68)
15 <STATUS> button
Displays the projector information.
16 <DEFAULT> button
Resets the setting of the displayed sub-menu to the factory
default. (x page 80)
17 <ID SET> button
Sets the ID number of the remote control in a multiple projector
environment. (x page 34)
18 Remote control signal transmitter
19 Remote control wired terminal
This is a terminal used to connect to the projector via a cable
when the remote control is used as a wired remote control.
(x page 34)
r Top
r Bottom
r Front