Panasonic PT-MZ20K

Chapter 4 Settings — [DISPLAY OPTION] menu
ENGLISH - 121
f To adjust the color unevenness per signal level, repeat Steps 3) to 10).
f To adjust the color unevenness for each image position, repeat Steps 7) to 10).
Initializing adjustments for [USER CORRECTION]
Return the setting values of the brightness for the selected [ADJUSTMENT LEVEL] and the color unevenness of
each image position to the factory setting values.
1) Press as to select [UNIFORMITY].
2) Press qw to select [USER CORRECTION], and press the <ENTER> button.
f The [UNIFORMITY:USER CORRECTION] screen is displayed.
3) Press as to select [ADJUSTMENT LEVEL].
4) Press qw to select the item to initialize in [ADJUSTMENT LEVEL].
5) Press asqw to select [INITIALIZE].
6) Press the <ENTER> button.
f The conrmation screen is displayed.
7) Press qw to select [OK], and press the <ENTER> button.
Note
f All correction data in [ADJUSTMENT LEVEL] cannot be initialized at once.
For each setting in [ADJUSTMENT LEVEL], select the item and execute [INITIALIZE] individually.
f To initialize correction data in [UNIFORMITY] at once, select the [PROJECTOR SETUP] menu → [INITIALIZE] → [UNIFORMITY ONLY] and
execute the initialization.
f [TEST PATTERN] is not initialized. Select the item and execute the initialization individually.
[SHUTTER SETTING]
Set the operation of the shutter function.
Setting [FADE-IN] or [FADE-OUT]
Set the image fade-in and fade-out when the shutter function operates.
1) Press as to select [SHUTTER SETTING].
2) Press the <ENTER> button.
f The [SHUTTER SETTING] screen is displayed.
3) Press as to select [FADE-IN] or [FADE-OUT].
4) Press qw to switch the item.
Item Adjustment
[FADE-IN]
[FADE-OUT]
[OFF] Does not set fade-in or fade-out.
[0.5s] - [10.0s]
Sets the fade-in or fade-out time.
Select an item from [0.5s] - [4.0s], [5.0s], [7.0s], or [10.0s]. [0.5s] -
[4.0s] can be selected in increments of 0.5.
Note
f Press the <SHUTTER> button on the remote control or the control panel during fade-in or fade-out to cancel the fade operation.
Setting [STARTUP]
Automatically enable/disable the shutter function (shutter: closed/opened) when the power is turned on.
1) Press as to select [SHUTTER SETTING].
2) Press the <ENTER> button.
f The [SHUTTER SETTING] screen is displayed.
3) Press as to select [STARTUP].