Panasonic PT-MZ20K

Chapter 4 Settings — [PROJECTOR SETUP] menu
146 - ENGLISH
[FILTER COUNTER]
Check the runtime of the lter and set the cleaning/replacement cycle of the lter. Also, the runtime of the lter can
be reset.
1) Press as to select [FILTER COUNTER].
2) Press the <ENTER> button.
f The [FILTER COUNTER] screen is displayed.
[FILTER COUNTER] Displays the runtime of the lter.
[TIMER] Sets the cleaning/replacement cycle of the lter.
[FILTER COUNTER RESET] Reset the runtime of the lter.
Setting [TIMER]
If the lter is to be cleaned/replaced periodically, set the cycle in hours. Once the runtime of the lter reaches
the set time, a message prompting to clean/replace the lter [FILTER COUNTER has reached the set time.] is
displayed on the projected image.
1) Press as to select [FILTER COUNTER].
2) Press the <ENTER> button.
f The [FILTER COUNTER] screen is displayed.
3) Press as to select [TIMER].
4) Press qw to switch the item.
f The items will switch each time you press the button.
[OFF] Select this item when a message is not to be displayed.
[1000 H] - [20000 H]
Select this item when a message is to be displayed. The cleaning/replacement cycle of the lter can
be set in 1 000 hour intervals.
Resetting [FILTER COUNTER]
Reset the runtime of the lter.
1) Press as to select [FILTER COUNTER].
2) Press the <ENTER> button.
f The [FILTER COUNTER] screen is displayed.
3) Press as to select [FILTER COUNTER RESET].
4) Press the <ENTER> button.
f The conrmation screen is displayed.
5) Press qw to select [OK], and press the <ENTER> button.
f Display of [FILTER COUNTER] will change to [0 H].
[STATUS]
Display the status of the projector.
1) Press as to select [STATUS].
2) Press the <ENTER> button.
f The [STATUS] screen is displayed.
3) Press qw to switch the pages.
f The page will change each time you press the button.
[PROJECTOR TYPE] Displays the type of the projector.
[SERIAL NUMBER] Displays the serial number of the projector.
[PROJECTOR RUNTIME] Displays the runtime of the projector.