Panasonic PT-MZ20K

Chapter 3 Basic Operations — Switching on/o󰀨 the projector
ENGLISH - 63
Initial setting (time zone)
Set [TIME ZONE] in accordance with the country or region where you use the projector.
After completed the initial setting, you can change the setting from the [PROJECTOR SETUP] menu → [DATE
AND TIME]. The current settings are displayed in [LOCAL DATE] and [LOCAL TIME].
1) Press qw to switch the setting.
+09:00
6/7
20XX/01/01
12 : 34 : 56
LOCAL DATE
LOCAL TIME
Please set up a time zone according to the area of your
country or region.
INITIAL SETTING
SET
CHANGEMENU SELECT
TIME ZONE
ENTER
2) Press the <ENTER> button to proceed to the initial setting.
Note
f In the factory default setting, the time zone of the projector is set to +09:00 (Japan and Korea Standard Time). Change the setting of the
[PROJECTOR SETUP] menu → [DATE AND TIME] → [TIME ZONE] to the time zone of the region where you use the projector.
Initial setting (date and time)
Set the local date and time.
After completed the initial setting, you can change the setting from the [PROJECTOR SETUP] menu → [DATE
AND TIME].
To set the date and time automatically, refer to “Setting the date and time automatically” (x page 139).
1) Press as to select an item.
20XX
7/7
1
1
12
34
56
MONTH
DAY
HOUR
MINUTE
SECOND
Please set the date and time of the built-in clock of the
projector.
INITIAL SETTING
SET
CHANGEMENU SELECT
YEAR
ENTER
2) Press qw to switch the setting.
3) Press the <ENTER> button.
f Conrm the setting value and complete the initial setting.
When the administrator account setting screen is displayed
When the projector is switched on for the rst time after purchase, or when the [PROJECTOR SETUP] menu →
[INITIALIZE] → [FACTORY RESET] is executed, the focus adjustment screen is displayed after the projection
starts, followed by the [INITIAL SETTING] screen and the [ADMINISTRATOR ACCOUNT] screen. If the
[PROJECTOR SETUP] menu → [INITIALIZE] → [NETWORK/E-MAIL ONLY] is executed, the [ADMINISTRATOR
ACCOUNT] screen is displayed after the projection starts.
To use the network function of this projector, set the user name and password of the administrator account. You
can also set it later from the [NETWORK] menu → [ADMINISTRATOR ACCOUNT].