Panasonic PT-MZ780

Chapter 4 Settings — [PROJECTOR SETUP] menu
124 - ENGLISH
Changing the menu code
The menu code that calls up the operation menu of the CEC-compatible device varies depending on the device
manufacturer. If you cannot call up the operation menu of a CEC-compatible device from the HDMI-CEC operation
screen, change the menu code setting.
1) Press
as
to select [HDMI CEC].
2) Press
qw
to select [ON].
3) Press the <ENTER> button.
f
The
[HDMI CEC]
screen is displayed.
4) Press
as
to select [MENU CODE].
5) Press
qw
to switch the item.
f
The items will switch each time you press the button.
f
Select the menu code from [1] to [6].
Setting the link control
Make settings for the link control between the projector and CEC-compatible devices.
[PROJECTOR -> DEVICE]
Set the link control from the projector to the CEC-compatible device.
1) Press
as
to select [HDMI CEC].
2) Press
qw
to select [ON].
3) Press the <ENTER> button.
f
The
[HDMI CEC]
screen is displayed.
4) Press
as
to select [PROJECTOR
->
DEVICE].
5) Press
qw
to switch the item.
f
The items will switch each time you press the button.
[DISABLE]
Disables the power link control from the projector to the CEC-compatible device.
Select this when you do not want the power status of the CEC-compatible device to link with the power status
of the projector.
[POWER OFF]
Enables power-off link control.
When you turn off the power of the projector and put it in standby mode, all CEC-compatible devices connected
to the <HDMI IN 1> terminal, <HDMI IN 2> terminal or <HDMI IN 3> terminal will enter standby mode.
Power-on link control is disabled.
[POWER ON/OFF]
Enables power-on link control and power-off link control.
If you turn on the projector and start projection with the HDMI1 input, HDMI2 input or HDMI3 input selected,
the CEC-compatible device connected to the selected input will turn on.
When you turn off the projector and put it in standby mode, all CEC-compatible devices connected to the
<HDMI IN 1> terminal, <HDMI IN 2> terminal or <HDMI IN 3> terminal will enter standby mode.
[DEVICE -> PROJECTOR]
Set the link control from the CEC-compatible device to the projector.
1) Press
as
to select [HDMI CEC].
2) Press
qw
to select [ON].
3) Press the <ENTER> button.
f
The
[HDMI CEC]
screen is displayed.
4) Press
as
to select [DEVICE
->
PROJECTOR].
5) Press
qw
to switch the item.
f
The items will switch each time you press the button.