Panasonic PT-MZ780

Chapter 3 Basic Operations — Operating with the remote control
ENGLISH - 67
Switching the image aspect ratio
Switch the image aspect ratio according to the input.
button
1) Press the <ASPECT> button.
f
The setting will change each time you press the button.
Note
f
Refer to the [POSITION] menu
→
[ASPECT] (
x
page 82) for details.
Using the presentation timer function
The presentation timer can be operated.
The presentation can be performed while conrming the elapsed time or remaining time against the specied time.
button
1) Press the <P-TIMER> button.
f
Starts the count.
2) Press the <P-TIMER> button again.
f
Stops the count.
Note
f
The elapsed time or remaining time is displayed at the bottom right of the projected image while using the presentation timer.
f
The count will restart when the <P-TIMER> button is pressed while the count is stopped.
f
The presentation timer is ended when the <P-TIMER> button is pressed and held for 3 seconds or longer.
f
For details such as setting of the presentation timer function, refer to the [DISPLAY OPTION] menu
→
[P-TIMER] (
x
page 105).
Using the function button
By assigning the following functions to the <FUNCTION> button, it can be used as a simplied shortcut button.
[SUB MEMORY], [SYSTEM SELECTOR], [DAYLIGHT VIEW]
button
1) Press the <FUNCTION> button.
Note
f
Assignment of the function is performed from the [PROJECTOR SETUP] menu
→
[FUNCTION BUTTON] (
x
page 117).
Displaying internal test pattern
To conrm the status of the projector, ten types of internal test patterns can be displayed. To display test patterns,
perform the following steps.
button
1) Press the <TEST PATTERN> button.
2) Press
qw
to select the test pattern.
Note
f
Test patterns can also be displayed using the menu operation. Refer to “[TEST PATTERN] menu” (
x
page 126) for details.
f
Settings of position, size, and other factors will not be reected in test patterns. Make sure to display the input signal before performing
various adjustments.