Panasonic PT-MZ780

Chapter 3 Basic Operations — Projecting
62 - ENGLISH
Lens shift range
The projector can adjust the position of the projected image within the lens shift range for each projection lens
based on the position of the projected image in the home position (standard projection position).
Following illustration indicates the lens shift range when the projector is installed on desk/oor.
Projection lens Model No.
Standard zoom lens/ET-ELS20/ET-ELW20/
ET-ELT22/ET-ELT23
ET-ELW22
Lens shift range
Projected image width H
Standard projection position
Projected image height V
0.35 H
0.30 H 0.30 H
0.35 H
0.67 V
0.67 V
0.19 V0.19 V
Projected image width H
Standard projection position
Projected image height V
0.30 H
0.25 H 0.25 H
0.30 H
0.60 V
0.60 V
0.15 V0.15 V
Note
f
Use the projection lens in the standard projection position without adjusting the lens shift when the optional Fixed-focus Lens (Model No.:
ET-ELW21) is attached.
Adjusting adjustable feet
Install the projector on a at surface so that the front of the projector is parallel to the screen surface and the
projection screen is rectangular.
If the screen is tilted downward, extend the front adjustable feet so that the projected image becomes rectangular.
The adjustable feet can also be used to adjust the projector to be level when it is tilted in the horizontal direction.
Adjustable feet can be extended by turning them as shown in the gure. Turning them in the opposite direction will
return them to the original position.
Maximum adjustable range
Adjustable feet: 23 mm (29/32") each
Attention
f
Be careful not to block the intake/exhaust vents with your hands or any objects when adjusting the adjustable feet while the light source is
on. (
x
page 29)