Panasonic PT-MZ780

Chapter 3 Basic Operations — Projecting
ENGLISH - 61
Setting the lens type
When the projector is used for the rst time or when the projection lens is replaced, conrm the [LENS TYPE]
setting. Change the setting if the type does not match the projection lens attached to the projector.
1) Press the <MENU> button.
f
The
[MAIN MENU]
screen is displayed.
2) Press
as
to select [PROJECTOR SETUP], and press the <ENTER> button.
f
The
[PROJECTOR SETUP]
screen is displayed.
3) Press
as
to select [LENS], and press the <ENTER> button.
f
The
[LENS]
screen is displayed.
4) Press
as
to select [LENS TYPE], and press the <ENTER> button.
f
The
[LENS TYPE]
screen is displayed.
5) Press
as
to select the lens type.
[ET-ELS20]
*1
Select this item when the standard zoom lens or the Zoom Lens (Model No.: ET-ELS20) is attached to
the projector.
[ET-ELW21]
Select this item when the Fixed-focus Lens (Model No.: ET-ELW21) is attached to the projector.
[ET-ELW22]
Select this item when the Zoom Lens (Model No.: ET-ELW22) is attached to the projector.
[ET-ELW20]
Select this item when the Zoom Lens (Model No.: ET-ELW20) is attached to the projector.
[ET-ELT22]
Select this item when the Zoom Lens (Model No.: ET-ELT22) is attached to the projector.
[ET-ELT23]
Select this item when the Zoom Lens (Model No.: ET-ELT23) is attached to the projector.
*1 This product is equivalent to the standard zoom lens.
6) Press the <ENTER> button.
f
The
[LENS CALIBRATION]
screen is displayed.
7) Press
qw
to select [OK], and press the <ENTER> button.
f
The lens calibration is started.
f
After completing the calibration, the projection lens will move to the home position.
f
To cancel, select [CANCEL]. In this case, the [LENS TYPE] setting is not changed.
Note
f
The lens shift range varies depending on the lens type. If [LENS TYPE] is set incorrectly, lens shift range may not be adjusted properly. For
details, see "Lens shift range" (
x
page 62).
Moving the lens position to the home position
To move the lens position to the home position, operate in following procedure.
1) Press the <DEFAULT> button on the remote control while the [SHIFT] adjustment screen is displayed.
f
The
[HOME POSITION]
screen is displayed.
LENS
HOME POSITION
EXECUTE
CANCEL
MENU
ENTER
2) Press the <ENTER> button while the [HOME POSITION] screen is displayed (approximately five
seconds).
f
[PROGRESS] is displayed in the
[HOME POSITION]
screen, and the lens position returns to the home
position.
Note
f
The home position of the lens is used when the lens is replaced or when the projector is stored, and it is not the optical center of the screen.
f
The
[HOME POSITION]
screen can also be displayed by pressing the <LENS/CANCEL> button on the control panel or the <SHIFT> button
on the remote control for three seconds or longer.