Panasonic PT-MZ780

Chapter 5 Operations — Using the data cloning function
ENGLISH - 163
9) Press the <ENTER> button.
f
To select multiple projectors, repeat Steps
8)
to
9)
.
10) Press the <DEFAULT> button on the remote control.
f
The conrmation screen is displayed.
11) Press
qw
to select [OK], and press the <ENTER> button.
f
Copy of the data between the projectors is started.
Once the copy is completed, the cloning result is displayed as a list in the
[DATA CLONING]
screen.
Meanings of the marks displayed in the list are as follows.
g
Green: Data copy has succeeded.
g
Red: Data copy has failed. Conrm the connection of the LAN cable and power status of the copy
destination projector.
f
Data is copied to the copy destination projector in the standby mode.
If the copy destination projector is in the projection mode, the data cloning request message is displayed,
and then the copy destination projector automatically shifts to the standby mode to start copy of data.
12) Turn on the power of the copy destination projector.
f
The copied content is reected on the copy destination projector.
Note
f
The security password is the password set in the [SECURITY] menu
→
[SECURITY PASSWORD CHANGE].
Initial password as the factory default:
awsqawsq
f
While data is being copied, the light source indicator <LIGHT>, the temperature indicator <TEMP>, and the lter indicator <FILTER> of the
destination projector will blink. Make sure that the indicators stop blinking before powering on the projector.
Setting [WRITE PROTECT]
Set if the copy of data using the data cloning function is permitted or not.
1) On the copy destination projector, press
as
to select [DATA CLONING].
2) Press the <ENTER> button.
f
The
[SECURITY PASSWORD]
screen is displayed.
3) Enter a security password and press the <ENTER> button.
f
The
[DATA CLONING]
screen is displayed.
4) Press
as
to select [WRITE PROTECT].
5) Press
qw
to switch the item.
f
The items will switch each time you press the button.
[OFF]
Permits operations of the data cloning function from another projector.
[ON]
Does not permit the operations of the data cloning function from another projector.
f
Data copy will not be possible when [ON] is set. When it is not necessary to copy data of another
projector, set to [ON] so that the data is not changed by mistake.
Note
f
The security password is the password set in the [SECURITY] menu
→
[SECURITY PASSWORD CHANGE].
Initial password as the factory default:
awsqawsq