Panasonic PT-MZ780

Chapter 6 Maintenance — Troubleshooting
ENGLISH - 179
Problems Points to be checked Page
Cannot control the projector
with Art-Net.
f
Are the connections between the twisted-pair-cable transmitter and an external device,
and between the twisted-pair-cable transmitter and projector correctly done?
―
f
Is [Art-Net SETUP] set to other than [OFF]? 142
f
Are [NET], [SUB NET], [UNIVERSE], and [START ADDRESS] set correctly? 142
The DIGITAL LINK input image
is not displayed.
f
Is the cable compatible to the condition of the projector used? 45
f
Are the connections between the twisted-pair-cable transmitter and an external device,
and between the twisted-pair-cable transmitter and projector correctly done?
―
f
Is [DIGITAL LINK MODE] set to [AUTO] or [DIGITAL LINK]? Is it set to [ETHERNET]? 134
f
Is a signal which is not compatible with a twisted-pair-cable transmitter being input? ―
Operation noise became loud.
If the temperature inside the projector becomes high, the speed of the internal cooling fan
increases automatically and the operation noise becomes loud. If the internal temperature
reaches the abnormal value, the indicators will light up or blink.
172
f
Is the ambient temperature high? 21
f
Is the air lter unit dirty? 174
f
Is the intake/exhaust vent blocked? 21
Attention
f
If problems persist even after checking the preceding points, consult your dealer.