Panasonic PT-MZ780

Chapter 7 Appendix — Specications
198 - ENGLISH
Connecting
terminals
<HDMI IN 1> terminal
<HDMI IN 2> terminal
<HDMI IN 3> terminal
HDMI x 3, HDCP 2.3 compatible, Deep Color compatible
Audio signal
Linear PCM (sampling frequency: 48 kHz/44.1 kHz/32 kHz)
<DIGITAL LINK/LAN>
terminal
RJ-45 x 1, for network and DIGITAL LINK connections (HDBaseT
TM
compliant), PJLink (class 2)
compatible, 100Base-TX, Art-Net compatible, HDCP 2.3 compatible, Deep Color compatible
<LAN> terminal
RJ-45 x 1, for network connection, PJLink (class 2) compatible, 10Base-T/100Base-TX, Art-Net
compatible
<COMPUTER IN>
terminal
High-density D-Sub 15 p (female) x 1
RGB signal
0.7 V [p-p] 75 Ω (SYNC ON GREEN: 1.0 V [p-p] 75 Ω)
SYNC/HD TTL high impedance, automatic positive/negative polarity
compatible
VD TTL high impedance, automatic positive/negative polarity
compatible
YP
B
P
R
signal
Y: 1.0 V [p-p] including synchronization signal, P
B
P
R
: 0.7 V [p-p] 75 Ω
<MONITOR OUT>
terminal
High-density D-Sub 15 p (female) x 1
RGB signal
0.7 V [p-p] 75 Ω (SYNC ON GREEN: 1.0 V [p-p] 75 Ω)
SYNC/HD TTL high impedance, positive/negative polarity
VD TTL high impedance, positive/negative polarity
YP
B
P
R
signal
Y: 1.0 V [p-p] including synchronization signal, P
B
P
R
: 0.7 V [p-p] 75 Ω
<AUDIO IN> terminal
M3 stereo mini jack x 1, 0.5 V [rms], input impedance 22 kΩ or more
<AUDIO OUT> terminal
M3 stereo mini jack x 1, 0 V [rms] to 2.0 V [rms] (variable), output impedance 2.2 kΩ or lower
<SERIAL/MULTI SYNC
IN> terminal
D-Sub 9 p x 1, RS-232C compliant, for computer control
<MULTI SYNC OUT>
terminal
D-Sub 9 p x 1
<REMOTE 1 IN> terminal
M3 stereo mini jack x 1, for remote control (wired)
<REMOTE 2 IN> terminal
D-Sub 9 p x 1, for contact control
<DC OUT> terminal
USB connector (type A) x 1, for power supply only (DC 5 V, maximum 2 A)
Acoustic noise
*1
PT-MZ880 34 dB
When [LIGHT POWER] in [ECO MANAGEMENT] is set to
[NORMAL] or [ECO].
PT-MZ780,
PT-MZ680
32 dB
PT-MZ880 27 dB
When [LIGHT POWER] in [ECO MANAGEMENT] is set to
[QUIET]
PT-MZ780,
PT-MZ680
26 dB
Operating
environment
Operating temperature
0 °C (32 °F) to 45 °C (113 °F)
*2
Operating humidity
20 % to 80 % (no condensation)
Operation position
[FLOOR/CEILING], [FRONT/REAR]
*1 Measurement, measuring conditions, and method of notation all comply with ISO/IEC 21118:2020 international standards.
*2 The projector cannot be used at an altitude of 2 700 m (8 858') or higher above sea level.
If the operating environment temperature exceeds the following value, the light output may be reduced to protect the projector.
f
When using the projector at an altitude lower than 700 m (2 297') above sea level: 38 °C (100 °F)
f
When using the projector at an altitude between 700 m (2 297') and 1 400 m (4 593') above sea level: 36 °C (97 °F)
f
When using the projector at an altitude between 1 400 m (4 593') and 2 100 m (6 890') above sea level: 34 °C (93 °F)
f
When using the projector at an altitude between 2 100 m (6 890') and 2 700 m (8 858') above sea level: 32 °C (90 °F)