6. Unscrew the 1 screw and remove the lamp unit terminal.
7. Remove the B/Q-Module.
6.8. Removal of P-P.C.Board
1. Remove the B/Q Module according to the section 6.7.
"Removal of B/Q Module".
2. Unscrew the 2 screws.
3. While lifting the P-P.C.Board, remove the power holder 1.
4. Slide the P-P.C.Board in the direction of the outside and
unhook the hook portion, then remove it.
6.9. Removal of Z-P.C.Board
1. Remove the P-P.C.Board according to the section 6.8.
"Removal of P-P.C.Board".
2. Unscrew the 2 screws and remove the light shield metal.
3. Unscrew the 2 screws and remove the A-P.C.Board.
Note:
·
A-P.C.Board is connected with J-P.C.Board with the
connector. Work carefully when removing it.
4. Unscrew the 1 screw and remove the Power fan and power
holder 2.
5. Remove the Z-P.C.Board.
6.10. Removal of Lamp Unit
1. Turn the projector upside down.
2. Loosen the 1 screw until it idles, remove the lamp unit
cover.
3. Loosen the 1 screw until it idles, remove the lamp unit with
the handle.
13
PT-P1SDU / PT-P1SDE / PT-P1SDEA
To Next Page
Loading...
