Panasonic pt-p1sdea

[Above figure is shown only the analysis block for explanation.]
7.5.3.2. Condenser Lens Holder Adjustment
1. Turn on the power and display 100 % white pattern on the screen.
2. Loosen the 2 screws fixing the condenser lens holder just until the holder can be shifted.
3. Adjust the condenser lens holder position to minimize color unevenness on the screen by shifting the holder in arrow directions.
4. Tighten the 2 screws.
7.5.3.3. Relay Lens Holder Adjustment
1. Turn on the power and display 100 % white pattern on the screen.
2. Loosen the 2 screws fixing the relay lens holder just until the holder can be shifted.
3. Adjust the relay lens holder position to minimize color unevenness on the screen by shifting the holder in arrow directions.
4. Tighten the 2 screws.
7.6. Software for Adjustment
7.6.1. Outline
· This projector needs computer-aided adjustments.
· After the software adjustments, this projector must be turned off and on again to memorize the settings.
· Connect the connection interface and communication cable between the projector and a PC as shown below.
· Updating the software will change the version number.
7.6.2. Operating Procedure
1. Run software program by the keyboard entry.
Note:
· Use the software program as below.
Adjustment Tool [P1SD]
2. The first menu is Port selection menu.
23
PT-P1SDU / PT-P1SDE / PT-P1SDEA