Repeat steps (1) to (3) until the green and blue crosshatch
patterns merge into a cyan pattern.
8. After the adjustment, reassemble the projector according to the section 6.13. "Replacement of LCD Panel (B)".
7.5. Lighting Area Adjustment
7.5.1. Tools to be used
Service Kit (Part No. TZSH07003): This kit is composed of 3 extension flexible cables and 2 connector extension cables.
Note:
·
Consult your dealer or Authorized Service Center for the service kit.
7.5.2. Preparation
1. Remove the upper case according to the section 6.2. "Removal of Upper Case".
2. Unscrew the 2 screws and remove the light shield metal.
3. Unscrew the 1 screw and remove the grounding metal 2.
4. Unscrew the 2 screws.
21
PT-P1SDU / PT-P1SDE / PT-P1SDEA
To Next Page
Loading...
