2 Ext Option
This projector has EXT OPTION in addition to standard on-screen menus.
·
There are SELF CHECK and SERVICE MODE for service, etc.
2.1. Procedure to enter EXT OPTION
1. Press "MENU" button on the remote control unit to display "MENU" screen, then select "OTHER SETUP" and press "ENTER"
button.
2. Select "HIGHTLAND" on "OTHER SETUP" menu and press "ENTER" button 3 seconds or longer.
MENU → OTHER SETUP → HIGHTLAND
2.2. EXT OPTION Menu and Functions
·
FREEZE MSG
Switching ON/OFF "FREEZE" on-screen display
·
ANGLE RESET
Resetting "AUTO SETUP (Correcting keystone distortion)" reference level
Note:
−
− −
− Normally, do not select. (Angle reset data will be rewritten.)
·
FAN FULLMODE
Setting the cooling fan motor rotation speed
−
− −
− Switching ON "FAN FULLMODE", the rotation level of the fan becomes high-speed rotation (fixed). Moreover, when "FAN
FULLMODE" is ON, changing "HIGHTLAND" in OTHER SETUP becomes impossible (setting FAN FULLMODE is given
priority more than HIGHTLAND).
·
AUTOSETUP
Setting AUTO SETUP mode
−
− −
− STANDARD: To set the normal mode (the dot clock is adjusted strictly))
−
− −
− SPECIAL: To set the special mode (the dot clock is adjusted roughly)
Note:
−
− −
− Do not change the initial setting (STANDARD).
·
SYNC
Setting SYNC processing mode
−
− −
− STANDARD: To set the normal mode
−
− −
− SPECIAL: To set the special mode (noise reduction mode)
Note:
−
− −
− Do not change the setting when it is possible to receive normally.
Change the setting only when the image is not displayed normally because of the sync signal noise of connected
equipment.
·
SELF CHECK
To enter the self-check mode
·
SERVICE MODE
6
PT-P1SDU / PT-P1SDE / PT-P1SDEA
To Next Page
Loading...
