Panasonic PT-RZ790

Chapter 4 Settings — [DISPLAY OPTION] menu
118 - ENGLISH
8) Press the <ENTER> button.
f
The
[VERTICAL SCAN FREQUENCY]
screen is displayed.
9) Press
qw
to switch [VERTICAL SCAN FREQUENCY].
f
Select [60Hz], [50Hz], [30Hz], [25Hz], or [24Hz] when [1920x1080p] is selected for [RESOLUTION].
f
Select [60Hz], [50Hz], or [48Hz] when [1920x1080i] is selected for [RESOLUTION].
f
Select [60Hz] or [50Hz] when anything other than following is selected for [RESOLUTION].
g
[1920x1080p], [1920x1080i]
10) Press the <ENTER> button.
f
The conrmation screen is displayed.
11) Press
qw
to select [OK], and press the <ENTER> button.
Note
f
The setting details are displayed in [RESOLUTION] and [VERTICAL SCAN FREQUENCY] of [EDID STATUS].
f
Setting of the resolution and the vertical scanning frequency may be necessary on the computer or video device in use.
f
The computer, video device, or projector in use may require the power to be turned off and on again after setting.
f
The output with the set resolution or vertical scanning frequency may not be possible depending on the computer or video device in use.
[SDI IN]
Set this item in accordance with the signal input to the <SDI IN> terminal.
Setting [RESOLUTION]
1) Press
as
to select [SDI IN].
2) Press the <ENTER> button.
f
The
[SDI IN]
screen is displayed.
3) Press
as
to select [RESOLUTION], and press the <ENTER> button.
f
The
[RESOLUTION]
screen is displayed.
4) Press
as
to select the item, and press the <ENTER> button.
f
Select [AUTO], [720x480i], [720x576i], [1280x720p], [1920x1080i], [1920x1080p], [1920x1080sF], or
[2048x1080p].
Setting [3G-SDI MAPPING]
1) Press
as
to select [SDI IN].
2) Press the <ENTER> button.
f
The
[SDI IN]
screen is displayed.
3) Press
as
to select [3G-SDI MAPPING].
4) Press
qw
to switch the item.
f
The items will switch each time you press the button.
[AUTO]
Automatically selects [LEVEL A] or [LEVEL B].
[LEVEL A]
Fixes the mapping method to 3G-SDI Level-A.
[LEVEL B]
Fixes the mapping method to 3G-SDI Level-B.
Note
f
This item does not operate during SD-SDI or HD-SDI signal input.
Setting [SYSTEM SELECTOR]
1) Press
as
to select [SDI IN].
2) Press the <ENTER> button.
f
The
[SDI IN]
screen is displayed.