Panasonic PT-RZ790

Chapter 3 Basic Operations — Projecting
72 - ENGLISH
Note
f
The projected image size and scale shown on the periphery focus adjustment ring are an approximate guide.
f
Set the [PROJECTOR SETUP] menu
→
[LENS]
→
[LENS TYPE] to [ET-DLE035] when using the Fixed-focus Lens (Model No.:
ET-DLE035).
Setting the lens type
If the projection lens is replaced, conrm the [LENS TYPE] setting. Change the setting if the type does not match
the projection lens attached to the projector.
1) Press the <MENU> button.
f
The
[MAIN MENU]
screen is displayed.
2) Press
as
to select [PROJECTOR SETUP].
3) Press the <ENTER> button.
f
The
[PROJECTOR SETUP]
screen is displayed.
4) Press
as
to select [LENS].
5) Press the <ENTER> button.
f
The
[LENS]
screen is displayed.
6) Press
as
to select [LENS TYPE].
7) Press
qw
to switch the item.
f
The items will switch each time you press the button.
[NORMAL]
Select this item when a projection lens anything other than the Zoom Lens (Model No.: ET-DLE020)
or the Fixed-focus Lens (Model No.: ET-DLE035) is used for projection.
[ET-DLE035]
Select this item when the Fixed-focus Lens (Model No.: ET-DLE035) is used for projection.
[ET-DLE020]
Select this item when the Zoom Lens (Model No.: ET-DLE020) is used for projection.
Moving the projection lens to the home position
Operate in following procedure to move the projection lens to the home position.
When operating from the main menu
1) Press the <MENU> button.
f
The
[MAIN MENU]
screen is displayed.
2) Press
as
to select [PROJECTOR SETUP].
3) Press the <ENTER> button.
f
The
[PROJECTOR SETUP]
screen is displayed.
4) Press
as
to select [LENS].
5) Press the <ENTER> button.
f
The
[LENS]
screen is displayed.
6) Press
as
to select [LENS HOME POSITION].
7) Press the <ENTER> button.
f
The conrmation screen is displayed.
8) Press
qw
to select [OK], and press the <ENTER> button.
f
The projection lens is moved to the home position.
Note
f
The projection lens is not moved to the correct home position when the [PROJECTOR SETUP] menu
→
[LENS]
→
[LENS TYPE] is set
incorrectly. Change the setting if the type does not match the projection lens attached to the projector.
f
The home position does not match with the optical image center position.
f
The home position varies depending on the projection lens type. Refer to “Lens shift range” (
x
page 73) for details.
f
The home position of the Fixed-focus Lens (Model No.: ET-DLE035) may deviate from the designed position.