Panasonic PT-RZ870LBEJ - [Lens Calibration]; [Status]

Chapter 4 Settings — [PROJECTOR SETUP] menu
138 - ENGLISH
[WAVEFORM MONITOR]
Displays the waveform of the input signal. (x page 116)
[ASPECT]
Switches the aspect ratio of the image. (x page 89)
[PROJECTION METHOD]
Switches the [PROJECTION METHOD] setting. (x page 119)
4) Press the <ENTER> button.
[LENS CALIBRATION]
Detect the lens shift limit value of the projector and set the home position and the ET-DLE030, ET-DLE035 lens
standard position automatically.
1) Press as to select [LENS CALIBRATION].
2) Press qw to switch the item.
f The items will switch each time you press the button.
[NORMAL]
Select this item when anything other than the Fixed-focus Lens (Model No.: ET-DLE030, ET-DLE035)
is used.
Move the lens to the home position after completing the calibration.
[DLE030]
Select this item when the Fixed-focus Lens (Model No.: ET-DLE030, ET-DLE035) is used.
Move the lens to the ET-DLE030, ET-DLE035 lens standard position after completing the calibration.
3) Press the <ENTER> button.
f The conrmation screen is displayed.
4) Press qw to select [OK], and press the <ENTER> button.
f To cancel, select [CANCEL].
f The lens moves up, down, left, and right to detect the lens shift limit value, and automatically set the home
position and the ET-DLE030, ET-DLE035 lens standard position.
f The lens stops to complete the calibration.
Note
f [PROGRESS] is displayed in the menu during lens calibration. The operation cannot be canceled during calibration.
f When lens calibration executes correctly, [COMPLETE] is displayed and [INCOMPLETE] is displayed when it does not execute correctly.
f Pressing the <FOCUS> button on the remote control for at least three seconds will also display the conrmation screen for lens calibration
execution.
f The home position is an origin position of the lens shift (vertical position and horizontal position of the lens) based on the calibration result. It
does not match with the optical image center position.
[STATUS]
Display the status of the projector.
1) Press as to select [STATUS].
2) Press the <ENTER> button.
f The [STATUS] screen is displayed.
3) Press qw to switch the pages.
f The page will change each time you press the button.
[PROJECTOR TYPE] Displays the projector type and serial number of the projector.
[PROJECTOR RUNTIME] Displays the runtime of the projector.
[LIGHT RUNTIME] Displays the runtime of the light source 1 and the light source 2.
[MAIN/SUB VERSION] Displays the main and sub versions of the rmware of the projector.
[INTAKE AIR TEMP.]
*1
Displays the status of the intake air temperature of the projector.
[OPTICS MODULE TEMP.]
*1
Displays the status of the internal temperature of the projector.
[EXHAUST AIR TEMP.]
*1
Displays the status of the exhaust air temperature of the projector.
[LIGHT1 TEMP.]
*1
Displays the light source 1 temperature status of the projector.
[LIGHT2 TEMP.]
*1
Displays the light source 2 temperature status of the projector.
[COOLING CONDITION] Displays the set cooling conditions.
[ATMOSPHERIC PRESSURE] Displays the atmospheric pressure.
[SELF TEST] Displays the status of the projector.
[INPUT] Displays the input terminal currently selected.