Chapter 3 Basic Operations — Projecting
ENGLISH - 69
2) Turn the periphery focus adjustment ring by hand to adjust the focus in the periphery of the screen.
Periphery focus adjustment ring
3) Check the focus at the center of the image again and make fine adjustments.
Note
f The projected image size and scale shown on the periphery focus adjustment ring are an approximate guide.
Adjusting the lens position and focus when the Fixed-focus Lens (Model No.:
ET-DLE030, ET-DLE035) is used
After attaching the projection lens, adjust the lens position and the focus with the projector correctly installed
against the screen.
By changing the projected image size, the focus balance in the center and periphery of the image may also be
lost. In such a case, adjust the focus balance in the center and periphery of the projected image on the Fixed-
focus Lens (Model No.: ET-DLE030, ET-DLE035).
1) Move the lens to the ET-DLE030, ET-DLE035 lens standard position.
f While the shift adjustment screen is displayed, press the <DEFAULT> button on the remote control to
display the [HOME POSITION] screen. Select [DLE030] to move the lens to the lens standard position.
Refer to “Setting the lens position” (x page 70) for details.
2) Adjust the focus at the center of projected image.
f For the steps to adjust the focus, refer to “Adjusting the focus, zoom, and lens shift” (x page 68).
3) Turn the periphery focus adjustment ring by hand to adjust the focus in the periphery of the screen.
Periphery focus adjustment ring
4) Check the focus at the center of the image again and make fine adjustments.
Note
f The projected image size and scale shown on the periphery focus adjustment ring are an approximate guide.
To Next Page
Loading...
