To enter the service mode
To enter the “Service mode”, press and hold the MENU button and ENTER button on the projector for more than
3 seconds or press and hold the MENU button on the remote control for more than 20 seconds. The service menu
appears on the screen as follows.
To adjust service data
Select the adjustment group no. by pressing the MENU button (increase) or ENTER button (decrease), and se-
lect the adjustment item no. by pressing the pointer e or d button, and change the data value by pressing the 7 or
8 button. Refer to the “Service adjustment data table” for further description of adjustment group no., item no. and
data value.
To exit the service mode
To exit the service mode, press the button.
Service adjustment menu operation
Electrical Adjustments
Service Mode
Input Computer 1
Group No. Data
0 0 +0
Ver. 1.00
Firmware version
Group no.
Item no.
Data value
Input mode
To Next Page
Loading...
