Panasonic PT-TW342

104 - ENGLISH
Cable specications
[When connected to a computer]
Projector
(<SERIAL IN> terminal)
1
NC NC
1
Computer
(DTE specications)
2 2
3 3
4
NC NC
4
5 5
6
NC NC
6
7 7
8 8
9
NC NC
9
Control commands
When controlling the projector from a computer, the following commands are available.
r Projector control command
Command Control contents Parameter/return string Remark (parameter)
PON Power on
―
To check if the power is on, use the “Power
query” command.
POF Power standby
IIS
Switching the input
signal
VID VIDEO
SVD S-VIDEO
RG1 RGB1
RG2 RGB2
HD1 HDMI
CP1 COMPONENT
MV1 MEMORY VIEWER
UD1 USB DISPLAY
NWP NETWORK
AUU Volume up
AUD Volume down
OSH AV mute function ―
Sending the command switches on/off. Do not
switch on/off in a short period of time.
AMT Mute function
0 Off
1 On
QPW Power query
000 Standby
001 Power on
Q$S Lamp condition query
0
1
2
3
Stand-by
Lamp ON control active
Lamp ON
Lamp OFF control active
Chapter 7 Appendix - Technical Information