ENGLISH - 75
About Memory Viewer function
The Memory Viewer function makes it is possible to project the video or still image stored in the USB memory.
What you can project with the Memory Viewer function
Memory Viewer function supports the following image les.
Video
Extension Video codec Audio codec Video format
avi MotionJpeg ADPCM
YUV 4:4:4, YUV 4:2:2, YUV 4:2:0
Maximum: 1 280 x 720, 30 fps
Picture
Extension
Format Description
jpg/jpeg
Baseline coding 24 bits
Progressive RGB 24 bits
Resolution : 8 x 8 ~ 10 000 x 10 000
Resolution : 8 x 8 ~ 1 280 x 800
bmp
Palette-based 1, 4, 8 bits,
RGB 24, 32 bits
The maximum resolution : 1 280 x 800
png True color 24 bits/48 bits The maximum resolution : 1 280 x 800
gif Palette-based 1, 4, 8 bits,
Palette - 24 bits color spaces;
The maximum resolution : 1 280 x 800
tif / tiff The maximum resolution : 1 280 x 800
pdf
Note
f The maximum size of le is 2 GB.
f The total number of folders/les that can be displayed is about 500 at the maximum. In addition, other than the supported
format as the above table cannot be displayed.
f You cannot play the les which is protected by Digital Rights Management (DRM).
f You cannot play the PDF les which are protected by security setting.
f It maybe impossible to resume playing even if the le is recorded in the supported format.
Cautions on using USB Memory
Please observe the following.
f Do not put USB memory or its cap within close reach of children. Swallowing them may cause suffocation.
f If the smoke or questionable odor rise, remove the USB memory from the projector, and then contact your dealer.
f Do not put water, chemical or oil to the USB memory. It may cause short out or re.
f Do not put foreign objects or put metal objects to the USB terminal. Static electricity may cause data loss or data corruption.
f Do not remove the USB memory from the computer or the projector while the USB memory is reading out or writing the
data. It may cause data loss or data corruption.
f Do not store the USB memory where high temperature, humid or dusty place or magnetized items are around.
Note
f It is compatible with the USB memory sold in the market.
f It cannot be used the other format other than the formatted with FAT16 and FAT32.
Inserting the USB memory
1) Insert the USB memory directly into the <USB A (VIEWER/WIRELESS)> terminal.
Attention
f When inserting the USB memory, conrm the direction of the plug and do not damage the terminal.
Removing the USB memory
1) Make sure that the USB memory is not flashing, and then unplug it.
Attention
f Please note following points when removing the USB memory.
- The indicator of the USB memory is blinking means that the projector is reading out the data. Do not remove the USB
memory while it is blinking.
- When using a USB memory without an indicator, you cannot recognize when the projector reading out the data. Please
remove it from the projector after closing the memory viewer function or turning off the projector.
- Do not insert and remove the USB memory in a short time. Remove the USB memory at least ve seconds after inserting.
And insert it at least ve seconds after removing. When inserting or removing the USB memory, the projector takes about
ve seconds to identify the operation.
Chapter 5 Operation of Function - About Memory Viewer function
To Next Page
Loading...
