Panasonic PT-VW345NZ

r [ENCRYPTION] setting
[NONE]
Select when transmit without encryption. It is selectable only when
[AUTHENTICATION] is [OPEN] or [SHARED].
[WEP]
Select when Encryption is WEP.
[TKIP]
Select when Encryption is TKIP.
Selectable when [AUTHENTICATION] is either [WPA-PSK], [WPA2-PSK],
[WPA-EAP], [WPA2-EAP].
[AES]
Select when Encryption is AES.
Selectable when [AUTHENTICATION] is either [WPA-PSK], [WPA2-PSK],
[WPA-EAP], [WPA2-EAP].
r When setting [OPEN] or [SHARED] as authentication and setting [WEP] as the encryption method:
[DEFAULT KEY]
Set 1 – 4 numerals for the default key.
[KEY1-KEY4]
Set a [WEP] key to the key number selected with [DEFAULT KEY].
Either the 64-bit or 128-bit WEP key can be set. For the 64-bit key, input 5
alphanumerics (or a 10-digit string for the hexadecimal format) for the 128-bit key,
input 13 alphanumerics (or a 26-digit string for the hexadecimal format).
r When setting [WPA-PSK] or [WPA2-PSK] as authentication method:
[KEY]
Set a key. Input either 8 to 63 alphanumerics or a 64 digit string in the
hexadecimal format.
r When the authentication method is [WPA-EAP/WPA2-EAP], [WPA-EAP], [WPA2-EAP]:
[EAP]
Select the EAP setup in the RADIUS server. Types of EAP that can be selected are
as follows.
PEAP (MS-CHAPv2), PEAP (GTC), EAP-TTLS (MD5), EAP-TTLS (MS-CHAPv2 ),
EAP-FAST (MS-CHAPv2), EAP-FAST (GTC)
[USE NAME]
Input a user name used for authentication (excluding spaces) (maximum 64
characters).
[PASSWORD]
Input a password used for authentication (maximum 64 characters).
Note
f If you are unable to connect to the wireless LAN through the access point even after performing the steps in "Projector
settings" (
Æ
page 93), contact the manufacturer of the access point (Radio repeater).
f When using EAP, the projector needs to be set according to the setting of the RADIUS server. Check with the network
administrator for the setting of the RADIUS server.
f When using an EAP together with an access point with invalid SSID broadcast, select WAP-EAP or WAP2-EAP for the
authentication method even if the authentication method of the access point is WPA-EAP/WPA2-EAP.
f If USER1 ~ 3 use, you can not connect to the access point of stealth SSID conguration, please use it to cancel the stealth
setting. For details, please refer to the Operating Instructions of the access point.
5) Press as to select [OK], and press the <ENTER> button.
r Default setting of [USER1], [USER2], [USER3]
f The following settings are set before the projector leaves the factory.
[SSID]
Panasonic Projector
[DHCP]
OFF
[IP ADDRESS]
192.16 8.11.10 0
[SUBNET MASK]
255.255.255.0
[DEFAULT GATEWAY]
192.16 8.11.1
[AUTHENTICATION]
OPEN
[ENCRYPTION]
NONE
[CHANNEL]
11
[DNS1]/[DNS2]
NONE
88 - ENGLISH
Chapter 4 Settings - [NETWORK/USB] menu