[CONNECTION TYPE]
Select the connection type when connecting to the projector with the MIRRORING function for the
rst time.
[AUTO]
Select to connect automatically.
[PIN]
Select to connect by entering the PIN at the device side when
a PIN (8-digit number) is displayed on the idle screen of the
MIRRORING.
[CHANNEL]
Select the channels to use.
[MOBILE CONNECTION]
Select when the connection is poor. Usually it is set to [OFF] in use.
[OFF]
Disable this function.
[ON]
Enable this function.
Note
f If [CONNECTION TYPE] is set to [AUTO] and the connection cannot be made for the device in use, set it to [PIN].
f When connecting a device that was connected to the projector once with the MIRRORING function, it is automatically connected regardless
of the setting of [CONNECTION TYPE].
Setting [MODERATOR MODE]
Set whether to enable [MODERATOR MODE] in which the moderator can designate the presenter when you
connect multiple devices to the projector with the MIRRORING function.
1) Press as to select [MIRRORING].
2) Press the <ENTER> button.
f The [MIRRORING] screen is displayed.
3) Press as to select [MODERATOR MODE].
4) Press qw to select the item.
f The items will switch each time you press the button.
[OFF]
Disables the moderator mode function.
Only one device screen can be displayed among the devices connected to the projector.
[ON]
Enables the moderator mode function.
Select this item when the moderator operates the projector and species the device screen to be
projected from multiple devices that are displayed on the idle screen.
Note
f The connection cut-in from other users is not possible when it is set to [ON].
f On how to operate in moderator mode with MIRRORING input, refer to “Projecting with MIRRORING” (
Æ
page 136).
Setting [CUT IN]
Set whether to allow connection cut-in by another user while the projector is displaying the screen of a user’s
device.
1) Press as to select [MIRRORING].
2) Press the <ENTER> button.
f The [MIRRORING] screen is displayed.
3) Press as to select [CUT IN].
4) Press qw to select the item.
f The items will switch each time you press the button.
[ON]
Enables the cut in function.
Cancel the connection with current device, connect to the device with a new connection request and
project its screen.
[OFF]
Disables the cut in function.
Maintain the connection with current device.
Note
f [CUT IN] cannot be set when [MODERATOR MODE] is set to [ON].
ENGLISH
-
107
Chapter 4 Settings - [NETWORK/USB] menu
To Next Page
Loading...
