[NETWORK STATUS]
Displays the network status.
1) Press as to select [NETWORK STATUS].
2) Press the <ENTER> button.
f The [NETWORK STATUS] screen is displayed.
3) Press as to switch between the screens.
f The pages will switch each time you press the button.
[WIRED LAN] (1/3 page), [WIRELESS LAN] (2/3 page), [WIRELESS LAN] (3/3 page)
[WIRED LAN]
Displays the network information of the wired LAN that set on the projector.
[DHCP]
Displays the usage state of the DHCP server.
[IP ADDRESS]
Displays the IP address.
[SUBNET MASK]
Displays the subnet mask.
[DEFAULT GATEWAY]
Displays the default gateway.
[DNS1]
Displays the address of the preferred DNS server.
[DNS2]
Displays the address of the alternate DNS server.
[MAC ADDRESS]
Displays the MAC address of wired LAN.
[EAP]
Displays the type of EAP.
[WIRELESS LAN]
Displays the network information of the wireless LAN that set on the projector.
[ANTENNA LEVEL]
Displays the radio wave state of the wireless LAN.
[NETWORK]
Displays the connection method of the wireless LAN.
[SSID]
Displays the character string of SSID.
[AUTHENTICATION]
Displays the user authentication method.
[EAP]
Displays the type of EAP.
[ENCRYPTION]
Displays the encryption method.
[DEFAULT KEY]
Displays the number of the default key.
[DHCP]
Displays the usage state of the DHCP server.
[IP ADDRESS]
Displays the IP address.
[SUBNET MASK]
Displays the subnet mask.
[DEFAULT GATEWAY]
Displays the default gateway.
[DNS1]
Displays the address of the preferred DNS server.
[DNS2]
Displays the address of the alternate DNS server.
[MAC ADDRESS]
Displays the MAC address of wireless LAN.
Note
f When [WIRELESS LAN] is set to [DISABLE], the [WIRELESS LAN] pages of the [NETWORK STATUS] screen will not be displayed.
[INITIALIZE]
This function is used to return various setting values of [NETWORK/USB] to the factory default value.
1) Press as to select [INITIALIZE].
2) Press the <ENTER> button.
3) When the [INITIALIZE] screen is displayed, press qw to select [OK] and then press the <ENTER> button.
Note
f If the [SECURITY] menu → [PASSWORD] is set to [ON], the [PASSWORD] screen will be displayed when [INITIALIZE] is selected and the
<ENTER> button is pressed. Continue your operation after entering the security password set for the projector.
ENGLISH
-
109
Chapter 4 Settings - [NETWORK/USB] menu
To Next Page
Loading...
