33
RQT8739
Adjusting the bass
• You can adjust the bass
through this operation.
1 Select and confirm the choice.
2 Make adjustment and confirm the choice.
Adjustment range:
-
10 dB to +10 dB
Factory setting: 0 dB
Adjusting the treble
• You can adjust the treble
through this operation.
1 Select and confirm the choice.
2 Make adjustment and confirm the choice.
Adjustment range:
-
10 dB to +10 dB
Factory setting: 0 dB
Balancing front speaker
volumes
• You can adjust the balance
of the front speakers.
1 Select and confirm the choice.
2 Make adjustment and confirm the choice.
L : Front left
R : Front right
You cannot adjust volume balance when you use SFC’s “PARTY ” mode (á pages 28 and 29).
Changing the audio
output (Dual program)
• The unit allows you to
switch dual audio signals in
Dolby Digital and DTS
formats.
“DUAL PRG
” appears on the display when the unit receives dual audio signals.
1 Select and confirm the choice.
2 Select audio and confirm the choice.
MAIN :
Main audio output
SAP :
Sub channel audio output
M+S :
Main and sub channel audio output
Factory setting: MAIN
Adjusting the
brightness of the
display
• Dim the display for better
viewing in a darkened room.
1 Select and confirm the choice.
2 Select a setting and confirm the choice.
• Select “DIMMER OFF ” to cancel.
• The light above [INPUT SELECTOR] and [VOLUME] goes
off when you make this adjustment.
Adjustment range:
DIMMER 1 (bright) to
DIMMER 3 (dim)
Factory setting: OFF
Sleep timer
• The sleep timer can turn the
unit off after a set time.
1 Select and confirm the choice.
2 Select the time and confirm the choice.
• When this is set, “SLEEP” appears on the display.
• To check the setting:
After setting the time, you can check the remaining time
using step 1.
• To change a setting:
Repeat the procedure from the beginning.
Times available for setting:
30, 60, 90, 120 (minutes)
Factory setting: OFF
Sleep timer is for this unit only.
The bar shows the standard balance.
Note
Note
Sound effects/Convenient functions
Operations
To Next Page
Loading...
