6.2. To return to the normal display
1. For U70 DVD
- Press some operation buttons on the AV control receiver.
- To re-display the code, switch the power off (Standby/on button), and then
switch power back on again.
2. For F61
- If F61 is displayed, the power will automatically be switched off and the
standby indicator will light up.
- F61 will be displayed for 3 seconds, and then the clock will be displayed.
- To re-display the code, switch the power on. F61 will be re-displayed, and
then after 3 seconds the clock will be displayed and the power will
automatically switch off.
6.3. Display contents
6.3.1. U70 DVD
- Problem or condition
A bus-line communications error has occurred as a result of the flat cable being
inserted incorrectly, thus preventing the system from operating.
- If U70 is displayed on the AV control receiver, DVD/CD player cannot be operated
by remote control.
- Correction Procedure
1. To check for correct insertion of flat cable.
- Insert connector until you hear a click.
- Make sure the white side of the cable is on your right side. Refer to
Fig. 6-2.
Fig. 6-2.
10
To Next Page
Loading...
