2. Breakage of flat cable. (Check and replace.)
3. If the problem is not corrected by items 1 and 2 above, this indicates a faulty IC.
SA-DT300:
IC941 (C2CBHG000095)
SL-DT300:
IC402 (C2BBFD000350)
Check these ICs and replace.
6.3.2. F61
- Problem or condition
When the Standby/on switch is switched on, it automatically switches back off,
making it impossible to switch power on.
- Correction procedure
Faulty AV control receiver (SA-DT300) power supply line or when a DC voltage is
applied to speaker terminals. (Check and replace.)
7. Operation Checks and Component Replacement
Procedures
- This section describes procedures for checking the operation of the major printed
circuit boards and replacing the main components.
- For reassembly after operation checks or replacement, reverse the respective
procedures. Special reassembly procedures are described only when required.
7.1. Checking for the digital amp P.C.B.
11
To Next Page
Loading...
