17
RQT0A83
Listening to FM radio
You can preset up to 30 channels.
Channel 1 to 5 will be set as the favourite stations
under (FAVOURITE) [1] to [5]. (l right, “Changing the
stations stored under (FAVOURITE) [1] to [5]”)
Preparation
≥ Make sure that the antenna is connected. (l 5)
≥ Turn the unit on.
≥ Press [RADIO, EXT-IN] repeatedly to select “FM”.
1 Press [PLAY MENU] to select “A.Preset”.
2 Press [2, 1] to select “Lowest” or “Current” and
then press [OK].
Lowest:
To begin auto preset with the lowest frequency
(“FM 87.50”).
Current:
To begin auto preset with the current frequency.*
1
≥ The tuner starts to preset all the stations it can receive
into the channels in ascending order.
*1: To change the frequency, refer to “Manual tuning”.
Press the numeric buttons, [:] or [9] to select
the preset station.
≥ Alternatively, press [:/6] or [5/9] on this unit
when “Preset” is selected as the tune mode*
2
.
≥ You can select channel 1 to 5 by touching one of
(FAVOURITE) [1] to [5] on this unit.
∫ Manual tuning
Press [6] or [5] to tune in to the station.
≥ Alternatively, press [:/6] or [5/9] on this unit
when “Manual” is selected as the tune mode*
2
.
To tune automatically, press and hold the button until the
frequency starts changing quickly.
*2: To change the tune mode
1 Press [PLAY MENU] repeatedly to select “Tune Mode”.
2 Press [2, 1] to select “Manual” or “Preset”, and then
press [OK].
1 While listening to the radio broadcast
Press [PGM, sDEL].
2 Press the numeric buttons to select a preset
number.
≥ Do steps 1 through 2 again to preset more stations.
≥ A station previously stored is overwritten when another
station is stored in the same channel preset.
You can change the stations stored under
(FAVOURITE) [1] to [5] easily.
While listening to the radio broadcast
Press and hold one of [1] to [5] until “P ” appears on
the display.
(“ ” stands for a number.)
≥ When you change the stations stored under (FAVOURITE)
[1] to [5], channel 1 to 5 are also changed to the same
corresponding stations.
∫ To display the current FM signal status
For Continental Europe:
Press [DISPLAY] repeatedly to select “FM Status”.
For others:
Press [DISPLAY].
≥ “Stereo” is displayed when this unit tunes to a stereo
broadcast.
∫ To display RDS text data
(For Continental Europe only)
This system can show the text data transmitted by the
radio data system (RDS) available in some areas.
Press [DISPLAY] repeatedly.
≥ RDS is available only when stereo works in reception.
≥ RDS may not be available if reception is poor.
Presetting stations automatically
Listening to a preset channel
Presetting stations manually
Changing the stations stored under
(FAVOURITE) [1] to [5]
“FM ST”: FM stereo broadcast is being received.
“FM - - - -”: No broadcast is received or FM
broadcast received is weak or in
monaural.
“FM Mono”: You have set the “FM Mode” to “Mono”.
(l 27, “If noise is excessive during FM
reception.”)
“PS”: Programme service
“PTY”: Programme type
“Freq”: Frequency
SC-ALL7CD_EGEBGN_RQT0A83-B.book 17 ページ ２０１６年３月１日 火曜日 午後４時１９分
To Next Page
Loading...
