12
VQT2S28
STEP 1: Preparing the
speakers
≥ Connecting the speaker cables. Insert the wire fully, taking
care not to insert beyond the wire insulation.
e.g. Front speaker
≥ For wall mount, refer to page 35.
≥ Be careful not to cross (short-circuit) or reverse the polarity of the
speaker wires as doing so may damage the speakers.
≥ To avoid injury by falling or dropping the speaker, place the speaker cables
with care not to stumble or hook.
STEP 2: Positioning
How you set up your speakers can affect the bass and the
sound field.
Setup example
Place the front speakers at approximately the same distance
from the seating position. The angles in the diagram are
approximate.
≥ Keep your speakers at least 10 mm away from the system for proper
ventilation.
A Front speakers
B Subwoofer
≥ Use only supplied speakers
Using other speakers can damage the unit, and sound quality will be
negatively affected.
≥ You can damage your speakers and shorten their useful life if you play
sound at high levels over extended periods.
≥ Place speakers on flat secure bases.
≥ Placing speakers too close to floors, walls, and corners can result in
excessive bass. Cover walls and windows with thick curtains.
∫ If irregular colouring occurs on your TV,
turn the TV off for about 30 minutes.
If it persists, move the speakers further away from the TV.
Push!
r: White
s: Blue line
Caution
≥ The main unit and supplied speakers are to be used
only as indicated in this setup. Failure to do so may
lead to damage to the amplifier and/or the speakers,
and may result in the risk of fire. Consult a qualified
service person if damage has occurred or if you
experience a sudden change in performance.
≥ Do not attempt to attach these speakers to walls using
methods other than those described in this manual.
≥ Do not touch the front netted area of the speakers. Hold
by the sides.
SCBT222EBEG_VQT2S28-B.book 12 ページ ２０１０年２月１２日 金曜日 午後１時４分
To Next Page
Loading...
