Advanced operations
Optional speaker
settings
35
VQT2S28
Speaker installation option
You can attach all of the speakers (except subwoofer) to a wall.
≥The wall or pillar on which the speakers are to be attached should be capable of supporting 10 kg per screw. Consult a qualified
building contractor when attaching the speakers to a wall. Improper attachment may result in damage to the wall and speakers.
≥Do not attempt to attach these speakers to walls using methods other than those described in this manual.
Preaparation
Remove the speaker bases.
1 Remove the screw from the speaker.
2 Remove the speaker base.
1 Drive a screw (not included) into the wall.
A At least 30 mm
B ‰ 4.0 mm
C ‰ 7.0 mm to ‰ 9.4 mm
D Wall or pillar
E 5.5 mm to 7.5 mm
2 Fit the speaker securely onto the screw(s)
with the hole(s).
Front speaker
A 48.5 mm
B In this position, the speaker will likely fall if moved to the
left or right.
C Move the speaker so that the screw is in this position.
∫ To avoid speaker dropping
Front speaker
≥ Consult a qualified building contractor to avoid damage to
the wall or speakers.
≥ Use a string of less than ‰ 2.0 mm, which is capable of
supporting over 10 kg.
≥Consult a qualified housing contractor concerning the appropriate procedure when attaching to a concrete wall or a surface that
may not have strong enough support. Improper attachment may result in damage to the wall or speakers.
≥Use a string of less than ‰ 2.0 mm, which is capable of supporting over 10 kg.
Front speaker
A String (not included)
Thread from the wall to the speaker and tie tightly.
B Rear of the speaker
C Screw eye (not included)
D Wall
E Approx.150 mm
Attaching to a wall
A String (not included)
B Screw eye (not included)
C Less than 10 cm
D Rear of the speaker
Preventing the speakers from falling
SCBT222EBEG_VQT2S28-B.book 35 ページ ２０１０年２月１２日 金曜日 午後１時４分
To Next Page
Loading...
