TV Radio
25
VQT2S28
TV
Enjoying TV with unit’s speakers
Preparation
Turn on your TV and select the appropriate audio input mode
[AUX, ARC, D-IN 1 or D-IN 2] to suit the connections to this
unit. (> 18)
You can enhance stereo sources with surround sound effect.
Press [SURROUND] several times to select the
effect.
For more detailed information on this operation, please refer to
the “Enjoying surround sound effects” section on page 19.
You can adjust the mode depending on the source or situation.
1 Press [SOUND] several times to select the
mode.
2 While the selected mode is displayed on the unit’s
display
Press [2, 1] and select the desired setting.
For more detailed information on this operation, please refer to
the “Changing the sound modes” section on page 19.
Select to suit the type of audio from the DIGITAL AUDIO IN
terminals on the main unit.
Press [EXT-IN] several times to select “D-IN 1”
(DIGITAL IN 1) or “D-IN 2” (DIGITAL IN 2).
∫ DIGITAL IN 1/DIGITAL IN 2
Press [AUDIO].
M1
M2
M1rM2 (stereo audio)
(Only works with Dolby Dual Mono)
≥ “M1” or “M2” is not available if “On” is selected in “Digital
Audio Input”. (> 32)
∫ DIGITAL IN 2
Press [STATUS].
CABLE/SAT AUDIO
Select when an HDMI connected STB is selected on the
TV, "D-IN 2" input is automatically selected. (> 26,
“Setting the audio link with the STB”).
≥ Audio that is input through the DIGITAL AUDIO IN or AUX terminals are not
output from the HDMI AV OUT terminal.
Surround sound effects
Sound modes
Making settings for digital
audio input
SCBT222EBEG_VQT2S28-B.book 25 ページ ２０１０年２月１２日 金曜日 午後１時４分
To Next Page
Loading...
