RQT9666
27
With this function turned on, this unit can be set to
automatically switch to standby mode if there is no signal
input and no operation is performed for 2 hours.
Press and hold [INPUT SELECTOR]
on the main unit for more than 2 sec.
≥ The indicator for the current setting blinks for 10 sec.
While the indicator is blinking, press
[INPUT SELECTOR] to change the
setting.
≥ The setting changes each time [INPUT SELECTOR] is
pressed.
∫ Remote control code
When other Panasonic devices respond to this system’s
remote control, change the remote control code on the
main unit and the remote control.
Preparation
≥ Turn off all other Panasonic products.
≥ Turn on the main unit.
Change the remote control code to code 2:
1 Aim the remote control at this system’s remote
control sensor.
2 Press and hold [MUTE] and [ ] on the remote
control for more than 4 sec.
≥ All the indicators will blink for 10 sec when the code of
this system is changed.
≥ The setting is maintained until it is changed again.
≥ If this system does not operate after changing the code,
repeat steps 1 and 2.
≥ To change the remote control code to code 1, repeat the
steps above, but replace
[] with [TV].
∫ To reduce the clear-mode dialog effect
When the dialog does not sound natural while the volume
is set low, for example, It is possible to reduce the dialog
enhancing effect as follows:
Press and hold [TV] on the remote control and [s VOL] on
the main unit for more than 2 sec.
≥ All the indicators will blink once when the clear-mode dialog
effect is reduced.
≥ Even if clear-mode dialog effect is reduced, dialog effect
level is still adjustable.
∫ To turn off VIERA Link “HDAVI
Control”
When “HDAVI Control” compatible equipment does not
work well with this system, for example, it is possible to
turn off this function as follows:
≥ When VIERA Link is turned off the ARC function is not
available. Be sure to connect the optical digital audio
cable. (> 19)
1 Press and hold [MUTE] on the remote control
and [s VOL] on the main unit for more than 2
sec.
2 After the setting has changed, turn off all the
connected devices and then turn them on
again.
≥ All the indicators will blink once when VIERA Link “HDAVI
Control” is turned off.
∫ To turn off the volume limitation
If a state of the lowered volume disturbs you every time
this system turns on, for example, it is possible to turn off
this function as follows:
Press and hold [MUTE] on the remote control and
[VOL r] on the main unit for more than 2 sec.
≥ All the indicators will blink once when the volume limitation
is turned off.
The settings of the clear-mode dialog effect, VIERA Link
“HDAVI Control”, and the volume limitation remain intact even
if you switch this system to standby mode. To turn these 3
functions back on, this system must be set back to the factory
preset. (> 28)
Auto standby function
Dolby Digital indicator blinks:
Auto standby function is on.
PCM indicator blinks:
Auto standby function is off.
Others
The following settings are unnecessary under
general usage conditions of the system.
SC-HTB550_RQT9660_mst.book Page 27 Monday, January 30, 2012 4:53 PM
To Next Page
Loading...
Need help?
General
Weight and Dimensions
