42
11.4.7. Disassembly of DAMP P.C.B.
• Refer to “Disassembly of Top Cabinet”.
• Refer to “Disassembly of Rear Panel”.
Step 1 : Remove 2 screws.
Step 2 : Detach 6P Cable Wire at the connector (CN5900) on
DAMP P.C.B..
Step 3 : Detach 40P FFC at the connector (CN5200) on DAMP
P. C . B . .
Step 4 : Remove the DAMP P.C.B. as shown.
Caution: During assembling, ensure that the DAMP P.C.B.
is seated properly on the locators.
To Next Page
Loading...
