Panasonic SC-HTB550GK - Page 75

75
11.6.5. Disassembly of Power Button
P. C .B .
• Refer to “Disassembly of Rear Panel Block”.
• Refer to “Disassembly of DAMP P.C.B.”.
Step 1 : Remove 2 screws.
Step 2 : Remove the Power Button P.C.B. as arrow shown.
Caution : During assembling, ensure that the Power Button
P.C.B. is seated properly onto the locators.
11.6.6. Disassembly of SMPS Module
P.C.B.
• Refer to “Disassembly of Rear Panel Block”.
Step 1 : Detach 7P Cable Wire at the connector (CN201) on
the SMPS Module P.C.B..
Step 2 : Remove 4 screws.
Caution : During assembling, ensure that the SMPS Mod-
ule P.C.B. is seated properly onto the locators.