13
TQBM0877
D:\New folder\PM700\Source\xml\PM700\PM700EB.EG_TQBM0877_EN.fm
█
Connecting a device
Preparation
If this system is connected to a Bluetooth
®
device, disconnect it (~13).
1 Press [ ].
“BLUETOOTH READY” is shown.
2 Select “SC-PM702/PM704” or “SC-PM700” from the Bluetooth
®
menu of the device.
The name of the connected device is shown for a few seconds.
3 Start playback on the device.
Note:
• A device must be paired to connect.
• This system can only connect to one device at a time.
• When “BLUETOOTH” is selected as the source, this system will automatically try to connect to the last
connected device. (“LINKING” is shown during this process.)
█
Disconnecting a device
While a Bluetooth
®
device is connected
1 Press [PLAY MENU] repeatedly to select “DISCONNECT?”.
2 Press [R, T] to select “OK? YES” and then press [OK].
“BLUETOOTH READY” is shown.
To cancel, select “OK? NO”.
Using the main unit
Press and hold [– PAIRING] until “PAIRING” is shown.
Note:
A device is disconnected when you:
– Select a different source.
– Move the device out of the maximum range.
– Disable the Bluetooth
®
transmission of the device.
– Switch off the system or the device.
PM700EB.EG_TQBM0877_EN.fm Page 13 Wednesday, March 15, 2023 2:48 PM
To Next Page
Loading...
